Buy 5052 aluminum plate to find Mingtai aluminum plate supplier

Buy 5052 aluminum plate to find Mingtai aluminum plate supplier:

The 5052 aluminum plate is an Al-Mg-Si alloy with medium strength, excellent plasticity and excellent corrosion resistance. In particular, there is no stress corrosion cracking tendency, and it has excellent weldability, good corrosion resistance and cold workability, and is a kind of alloy which has a wide range of use and is very promising. It can be anodized or painted. It contains a small amount of Cu, so the strength is higher than 6063, but the quenching sensitivity is also higher than 6063. After quenching, wind quenching cannot be achieved. The demand for solid solution treatment and quenching aging is required to achieve higher strength.

5052 aluminum plate has good forming processability, corrosion resistance, erodibility, fatigue strength and moderate static strength. This alloy has high plasticity and corrosion resistance, can not be heat-treated and strengthened, and has good plasticity during semi-cold hardening. Low plasticity during hardening; good weldability. Often used in the manufacture of aircraft fuel tanks, oil pipes, as well as transportation vehicles, ship sheet metal parts, instruments, street lamp brackets and rivets, hardware products.

How to choose 5052 aluminum plate:

Hardness

Most of the customers are mainly concerned with the hardness of aluminum. In fact, hardness is not the main consideration for aluminum selection. Generally speaking, there is a positive correlation between hardness and strength.

Strength

Usually refers to tensile strength, strength is a key factor to consider when applying aluminum. Insufficient strength can cause parts to deform and fail, resulting in malfunctions. Pure aluminum is the softest and has the lowest strength, while the 2 and 7 series heat treated alloys have the highest strength. Each alloy has a large difference in strength depending on the state, so when selecting the strength of the alloy, it is necessary to consider both the alloy system and the state.

Corrosion resistance

Corrosion resistance of aluminum, 5052 aluminum plate is an alloy with excellent corrosion resistance, and it is generally excellent in anodizing, surface treatment and coating properties. In general, the corrosion resistance of the 5 series is good, followed by the 3 series and the 6 series, and the 2 series and the 7 series are poor. The selection principle of the corrosion resistance should be determined according to the place of use.

Mingtai 5052 aluminum plate process specifications:

1. Surfaces are not allowed to have cracks, corrosion spots and traces of nitrate.
2. The surface shall be allowed to have peeling, air bubbles, surface roughness and local mechanical damage with a depth not exceeding 8% of the nominal thickness of the part where the defect is located, but the maximum depth of the defect shall not exceed 0.5 mm, and the total area of the defect shall not exceed the total area of the plate. 5%.
3, tensile strength (σb): 170 ~ 305MPa
4.The thickness of the aluminum plate is 0.15-600mm, the width is 20-2600mm, and the length is 500-16000mm.

Mingtai 5052 aluminum plate manufacturer

The 5052 aluminum plate produced by Henan Mingtai has been used for more than 10 years. Now it has become a inspection-free product for many customers. The products have been established in South China, East China market, and exported to Europe, North America, Southeast Asia, Middle East and other overseas markets. Very good market reputation. Mature process, active business contact, and excellent after-sales service make many dealers and manufacturers rely on Mingtai Aluminum.